MCS Chassis Wiring Harness Replacement

TM 9-2320-363-34-1 · Chapter 4 — Electrical System Maintenance

This task covers: a. Removal b. Cleaning c. Inspection d. Installation

Applicable Configuration:                                 References:

M917A1 w/MCS                                              TM 9-2320-363-20

Tools and Special Equipment:                              Equipment Condition:

Shop Equipment, SC 4910-95-CL-A31                         Reference              Condition Description
Tool Kit, SC 5180-90-CL-N05
                                                          TM 9-2320-363-20       Batteries Disconnected

                                                   NOTE

    l    Wiring harness and leads are secured in place by wire ties, cushion clamps, and screw terminals
    l    Only remove hardware securing harness or lead to be removed.

    DISCONNECT AND REMOVE MATERIAL CONTROL SYSTEM (MCS) CHASSIS WIRING HARNESS
    USING ILLUSTRATION AND TABLE AS A GUIDE.

    Use general cleaning methods to clean all parts (page 2-30).

    Inspect all parts for wear or damage.

                                                   NOTE
    l   Wiring harness and leads are secured in place by wire ties, cushion clamps, and screw
         terminals.
    l    Make sure harness is secure and all hardware is tight.

    INSTALL AND CONNECT MATERIAL CONTROL SYSTEM (MCS) CHASSIS WIRING HARNESS USING
    ILLUSTRATION AND TABLE AS A GUIDE.

                                              NOTE
                                      Follow-on Maintenance:
    Connect batteries (TM 9-2320-363-20).

TABLE QTY

1     2-Pin Connector      1
2     6-Pin Connector      2
3     8-Pin Connector      5

Connect batteries (TM 9-2320-363-20).