Engine Power Wiring Harness Replacement

TM 9-2320-363-34-1 · Chapter 4 — Electrical System Maintenance

This task covers: a. Removal b. Cleaning c. Inspection d. Installation

Tools and Special Equipment:                            Equipment Condition:

Tool Kit, SC 5180-90-CL-N05                             Reference              Condition Description

 References:                                            TM 9-2320-363-20       Batteries Disconnected

TM 9-2320-363-20

                                                   NOTE

       l      Wiring harness and leads are secured in place by cushion clamps and screw
            terminals.

       l     Only remove hardware securing harness or lead to be removed.

       DISCONNECT AND REMOVE ENGINE POWER WIRING HARNESS USING ILLUSTRATION AND
       TABLE AS A GUIDE.

       Use general cleaning methods to clean all parts (page 2-30).

       Inspect all parts for wear or damage.

                                                   NOTE
        l     Wiring harness and leads are secured in place by cushion clamps and screw
            terminals.

        l    Make sure harness is secure and all hardware is tight.

       INSTALL AND CONNECT ENGINE POWER WIRING HARNESS USING ILLUSTRATION AND TABLE
       AS A GUIDE.

                                                   NOTE
                                    Follow-on Maintenance:
        Connect batteries (TM 9-2320-363-20).

                                M915A2 and M916A1

TABLE                      QTY

1       Fuse Holder Plug    2
2       1-Pin Connector     1
3       6-Pin Connector     1
4       Terminal            4
5       Screw               1
6       Washer              1
7       Nut                 1
8       Clamp               1
9       Crown Nut           2

                           ALL EXCEPT M915A2 AND M916A1

TABLE                         QTY

1        Fuse Holder           1
2        1-Pin Connector       1
3        5-Pin Connector       1
4        Ring Terminal         3
5        Screw                 1
6        Washer                1
7        Nut                   1
8        Clamp                 1
9        Crown Nut             2
10       2-Pin Connector       1

THIS PAGE INTENTIONALLY LEFT BLANK