Electronic Control Module Wiring Harness Replacement

TM 9-2320-363-34-1 · Chapter 4 — Electrical System Maintenance

This task covers: a. Removal b. Cleaning c. Inspection d. Installation

                                                        References:
Tools and Special Equipment:
                                                        TM 9-2320-363-20
Tool Kit, SC 5180-90-CL-N05
                                                        Equipment Condition:
Materials/Parts:
                                                        Reference              Condition Description
Strap, Tie-down        Appendix B, Item 54.1
                                                        TM 9-2320-363-20       Batteries Disconnected

                                                 NOTE
       l       Wiring harness and leads are secured in place by cushion clamps and screws and
               tie-down straps.
       l       Only remove hardware securing harness or lead to be removed.

       DISCONNECT AND REMOVE ELECTRONIC CONTROL MODULE WIRING HARNESS USING
       ILLUSTRATION AND TABLE AS A GUIDE.

        Use general cleaning methods to clean all parts (page 2-30).

        Inspect all parts for wear or damage.

                                                 NOTE
        l      Wiring harness and leads are secured in place by cushion clamps and screws and
               tie-down straps.
        l      Only remove hardware securing harness or lead to be removed.

        INSTALL AND CONNECT ELECTRONIC CONTROL MODULE WIRING HARNESS USING
        ILLUSTRATION AND TABLE AS A GUIDE.

                                               NOTE
                                       Follow-on Maintenance:
        Connect batteries (TM 9-2320-363-20).
TM page Change 1 4-17
TABLE                     QTY

1       30-Pin Plug       1
2       3-Pin Connector   2
3       2-Pin Connector   3
4       Connector         4
5       Screw             5
6       Clamp             6
TM page 4-17.0 Change 1
(CONT)

                             ALL EXCEPT M915A2 AND M916A1

 TABLE                          QTY

 1        30-Pin Connector       1
 2        5-Pin Connector        2
 3        1-Pin Connector        6
 4        Screw                  7
 5        Clamp                  5
 6        Cover                  1
 7        Tie Strap              9
TM page Change 1 4-17.1

THIS PAGE INTENTIONALLY LEFT BLANK

TM page 4-18