Cab Floor Anti-Lock Brake System (ABS) Wiring Harness

TM 9-2320-363-34-1 · Chapter 4 — Electrical System Maintenance

REPLACEMENT

This task covers: a. Removal b. Cleaning c. Inspection d. Installation

Tools and Special Equipment:
                                                        Equipment Condition:
Shop Equipment, SC 4910-95-CL-A31
                                                        Reference              Condition Description
Tool Kit, SC 5180-90-CL-N05
                                                        TM 9-2320-363-20       Batteries Disconnected
References:

TM 9-2320-363-20

                                                 NOTE
       l       Wiring harness and leads are secured in place by wire ties, cushion clamps, and
               screw terminals.

       l       Only remove hardware securing harness or lead to be removed.

       DISCONNECT AND REMOVE CAB FLOOR ABS WIRING HARNESS USING ILLUSTRATION AND
       TABLE AS A GUIDE.

       Use general cleaning methods to clean all parts (page 2-30).

       Inspect all parts for wear or damage.

                                                 NOTE
       l       Wiring harness and leads are secured in place by wire ties, cushion clamps, and
               screw terminals.

       l       Make sure harness is secure and all hardware is tight.

       INSTALL AND CONNECT CAB FLOOR WIRING HARNESS USING ILLUSTRATION AND TABLE
       AS A GUIDE.

                                              NOTE
                                      Follow-on Maintenance:
       Connect batteries (TM 9-2320-363-20).

QTY TABLE

1 4-Pin Female Connector 1 2 3-Pin Female Connector 1 3 1-Pin Female Connector 1

REPLACEMENT (CONT)

ALL EXCEPT M915A2 AND M916A1

TABLE QTY

1     4-Pin Male Connector      2
2     6-Pin Male Connector      2
3     6-Pin Female Connector    1
4     6-Pin Female Connector    1

THIS PAGE INTENTIONALLY LEFT BLANK